Standard equipment of motor (rack) boats of the LP Navigator series

1) Welded cylinder frame with two or three independent pressurized compartments.

2) Along the cylinders of the boat, a fender 9 cm wide with a wave baffle is glued.

3) A lifeline 8-10 mm thick is glued along the outer perimeter of the boat.

4) Type of the bottom – high-strength waterproof plywood (batten), 9 mm thick with a non-slip coating. Depending on the length of the boat, the floor consists of 5 to 7 planks.

5) Reinforced stationary transom made of waterproof plywood 18 mm thick is glued into the aft part of the cylinders. The upper part of the transom is equipped with a protective lining, and in the lower part there is a drain valve.

6) To ensure mooring and transportation of the boat to the shore, a handle is installed in the bow.

7) An eye ring is used to fasten the anchor cable in the bow.

8) Two movable seats are easily adjustable along the entire length of the rails.

9) Two collapsible aluminium oars 1.4 meters long.

10) Foot boat pump for 6 litres.

11) PVC boat repair kit (PVC material, glue).

12) Operation manual.

13) Small craft certificate.

14) Packing bag for the boat – 1 pc.

15) Basic colours: green, khaki, dark grey, light grey.